Getting To Know The Av Receiver; Front Panel - Onkyo TX-NR905 Instruction Manual

Getting to Know the AV Receiver

Front Panel

3
1 2 4
STANDBY/ON
STANDBY
READY
ZONE 2
ZONE 3
PURE AUDIO AUDIO SEL
J K
The actual front panel has various logos printed on it. They are not shown here for clarity.
For detailed information, see the pages in parentheses.
A
STANDBY/ON button (50)
Sets the AV receiver to On or Standby.
B
STANDBY indicator (50)
Lights up when the AV receiver is on Standby and
flashes while a signal is being received from the
remote controller.
C
READY indicator (109)
North American model doesn't have this indicator.
Lights up when the AV receiver is on Standby and
HDMI Power Control is enabled.
D
ZONE 2 indicator (123)
Flashes when Zone 2 is being set. Lights up when
Zone 2 is on.
E
ZONE 3 indicator (123)
Flashes when Zone 3 is being set. Lights up when
Zone 3 is on.
F
Remote-control sensor (15)
Receives control signals from the remote controller.
G
Display
See "Display" on page 11.
H
DISPLAY button (77)
Displays various information about the currently
selected input source.
Not North American model
5 6
DVD VCR/DVR CBL/SAT GAME/TV AUX 1
L
7
AUX 2 TAPE TUNER CD PHONO
Front flap
I
MASTER VOLUME control (68)
Sets the volume of the AV receiver to –∞ dB,
–81.5 dB, –81.0 dB through +18.0 dB (relative dis-
play).
The volume level can also be displayed as an abso-
lute value. See "Volume Setup" on page 106.
J
PURE AUDIO button and indicator (79)
Selects the Pure Audio listening mode. The indica-
tor lights up when this mode is selected. Pressing
this button again selects the previous listening
mode.
K
AUDIO SEL button (78)
Selects the audio input: analog, digital, HDMI, or
multichannel.
L
Input selector buttons (68)
Select the following input sources: DVD,
VCR/DVR, CBL/SAT, GAME/TV, AUX 1, AUX 2,
TAPE, TUNER, CD, PHONO, NET/USB.
8 9
MASTER VOLUME
NET/USB DISPLAY
PUSH TO OPEN
Push here to open
the flap
9