Setup Using Auto Pc; Selecting An Input Signal (Analog Pc Input) - Canon WUX6000 User Manual

Setting Display Status (Input Settings)

Setup Using Auto PC

> [Input settings] >
HDMI Component
Digital PC Analog PC
Automatically adjusts display
position misalignment and screen
flickering. The adjusted result is
stored in the memory.
Press the OK button to accept your
setting.
If the Auto PC adjustment is
insufficient, perform the following
operations.
• Select the input signal that matches
the resolution of the computer from
[Input signal select]. (P76)
• If adjustment is insufficient even
when using the above operation,
adjust [Total dots], [Tracking],
[Horizontal/Vertical position] and
[Horizontal/Vertical pixels] in [Input
signal settings]. (P77, P78)
• For the signal types supported by
the projector, see the table on
214.
[Auto PC]
LAN
USB
page
76
Selecting an Input
Signal
(Analog PC Input)
> [Input settings] >
select]
HDMI Component
Digital PC Analog PC
You can select a suitable resolution
if the auto PC adjustment function
(P43) cannot project the correct
image from a computer.
Select an input signal corresponding to
the resolution of the computer.
Press the OK button to accept your
setting and then press the MENU
button.
• For the signal types supported by the
projector, see the table on
[Input signal
LAN
USB
page 214.