Table of Contents
Advertisement
Error Processing
9-2-7
Memory Error Check
Memory error occurred
Flash Memory Error Flag
(A403.10) ON?
OFF
Was power
interrupted while backing
up memory with the CX-
Programmer?
9-2-8
Program Error Check
Program error occurred
Task Error Flag
(A405.12) ON?
No END Error Flag
(A405.11) ON?
OFF
252
ON
Yes
No
ON
OFF
ON
The internal flash memory's rewrite limit has
been exceeded. Replace the Module.
The power supply was turned OFF during a
memory backup. Transfer the data again.
There was a hardware failure in the internal
memory. Replace the Module.
The called task does not exist. Check the
MSKS instruction that enables the interrupt
task with the corresponding task number.
There isn't an END instruciton in the
program. Add an END instruction.
Turn the power supply OFF and ON again.
Section 9-2
Advertisement
Chapters
Table of Contents
