Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-CM001 Operation Manual page 340

System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations
Baud Rate
Address
Word Bits
+161 00 to 07 00 hex: 9,600
06 hex: 9,600
07 hex: 19,200
08 hex: 38,400
09 hex: 57,600
Unit: bit/s
Default: 00 hex
RS-232 Port Settings for No-protocol Communications (RS-232C)
Serial Communications Mode
Address
Word Bits
+160 08 to 11 03 hex: No-protocol
Default: 00 hex
Data Format
Address
Word Bits
+160 15 0: Default format
1: Custom
Default: 00 hex
03 0: 7-bit
1: 8-bit
Default: 0
02 0: 2 bits
1: 1 bit
Default: 0
00 and 00: Even
01
01: Odd
10: None
Default: 00 hex
Baud Rate
Address
Word Bits
+161 00 to 07 00 hex: 9,600
01 hex: 300
02 hex: 600
03 hex: 1,200
04 hex: 2,400
05 hex: 4,800
06 hex: 9,600
07 hex: 19,200
08 hex: 38,400
09 hex: 57,600
Unit: bit/s
Default: 00 hex
Send Delay
Address
Word Bits
+162 00 to 15 Send delay time,
0 to 99,990 ms
(0000 to 270F hex,
unit: 10 ms)
Default: 0000 hex
Settings
Only settings 00 hex and 06 to 09 hex
can be used in peripheral bus mode.
Settings
This setting determines whether the
RS-232C port will operate in No-proto-
col mode or another serial communica-
tions mode. Set 03 for No-protocol
Mode.
Settings
The standard settings are for 1 start bit,
7-bit data, even parity, 2 stop bits, and
9,600 baud.
Sets the data length.
Sets the number of stop bits.
Sets the parity.
Settings
This setting is valid when the RS-232C
port is set for the No-protocol Serial
Communications Mode. Set the Data
Format setting to 1 to enable this set-
ting.
Settings
When TXD(236) is executed, data will
be sent from the RS-232C port after the
delay time set here.
Function Related flags and
A410.15 (RS-232C Port
Settings Changing Flag)
Function Related flags and
A410.15 (RS-232C Port
Settings Changing Flag)
Function Related flags and
A410.15 (RS-232C Port
Settings Changing Flag)
Function Related flags and
A410.15 (RS-232C Port
Settings Changing Flag)
Function Related flags and
A410.15 (RS-232C Port
Settings Changing Flag)
Appendix C
When setting is
words read
At next cycle (Also
can be changed
with STUP (237).)
When setting is
words read
At next cycle (Also
can be changed
with STUP (237).)
When setting is
words read
At next cycle (Also
can be changed
with STUP (237).)
When setting is
words read
At next cycle (Also
can be changed
with STUP (237).)
When setting is
words read
At next cycle (Also
can be changed
with STUP (237).)
317