Table of Contents
Advertisement
6
DSC OPERATION
■ MMSI code programming
The 9 digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
This code programming can only be performed TWICE.
q First, turn OFF the transceiver. Then, while holding down
[MENU], push [POWER] to turn ON the transceiver to
enter the MMSI code programming mode.
w After the DSC menu screen is displayed, release [MENU].
e Enter "MMSI check" in the DSC Set up menu.
DSC Menu
(Push [MENU])
r Edit the specific MMSI code by pushing the keypad keys.
• Rotate [SELECTOR] to move the cursor backward or forward.
//5+ %JGEM
AAAAAAAAA
%.4 'ZKV '06 1-
t After carefully entering the 9 digit code, then push [ENT]
to set the code.
• Returns to the DSC set up menu.
y Push [CLR] or rotate [SELECTOR] to select "Exit,"
then push [ENT] to return to the DSC menu.
• Push [ENT] again to return to the normal operating mode.
16
➪
➪
Set up
MMSI Check
(Rotate [SELECTOR], then push [ENT].)
&5% /GPW
■ DSC address ID
A total of 100 DSC address IDs can be entered, and a name
of up to 10 characters assigned to the ID.
D Programming Individual ID
q Enter "Add:INDV ID" in the DSC Set up menu.
➪
DSC Menu
Set up
(Push [MENU])
(Rotate [SELECTOR], then push [ENT].)
w Set the individual ID and ID name by pushing the keypad
keys.
• Edit the 9 digits of the appropriate distress ID directly with the
keypad.
• Rotate [SELECTOR] to move the cursor backward or forward.
• Push [CE] to clear the ID and name.
• Push [CLR] to cancel and exit the screen.
&5% /GPW
#FF +PFKXKFWCN +&
+PRWV FKIKVU
AAAAAAAAA
+PRWV PCOG
AAAAAAAAA
%.4 'ZKV '06 1-
e Push [ENT] to set the ID and return to the DSC set up
menu.
r Push [CLR] or rotate [SELECTOR] to select "Exit,"
then push [ENT] to return to the DSC menu.
• Push [ENT] again to return to the normal operating mode.
➪
Add:INDV ID
Advertisement
Table of Contents
