Precautions - Icom IC-M604A Instruction Manual

Hide thumbs Also See for IC-M604A:
Table of Contents

Advertisement

PRECAUTIONS

RWARNING! NEVER
This may pose a fire hazard or result in an electric shock.
RWARNING! NEVER
source of more than 16 V DC or use reverse polarity. This will
ruin the transceiver.
RWARNING! NEVER
the DC plug at the back of the transceiver and fuse holder. If an
incorrect connection is made after cutting, the transceiver may
be damaged.
RWARNING! NEVER
lightning storm. It may result in an electric shock, cause a fire or
damage the transceiver. Always disconnect the power source
and antenna before a storm.
CAUTION: NEVER
operation of the vessel may be hindered or where it could cause
bodily injury.
CAUTION:
Changes or modifications to this device, not
expressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
KEEP
the transceiver and microphone at least 1 m (3.3 ft)
away from the vessel's magnetic navigation compass.
DO NOT
operate or place the transceiver in areas with
temperatures below –20°C (–4°F) or above +60°C (+140°F) or,
in areas subject to direct sunlight, such as the dashboard.
v
connect the transceiver to an AC outlet.
connect the transceiver to a power
cut the DC power cable between
operate the transceiver during a
place the transceiver where normal
DO NOT
use harsh solvents such as benzine or alcohol to
clean the transceiver, as they will damage the transceiver's
surfaces. If the transceiver becomes dusty or dirty, wipe it clean
with a soft, dry cloth.
BE CAREFUL!
The transceiver rear panel will become hot
when operating continuously for long periods of time.
Place the transceiver in a secure place to avoid inadvertent use
by children.
BE CAREFUL!
The transceiver and the optional HM-157
™/HM-162*
commandmicii
commandmiciii
construction, which corresponds to IPX7. However, once the
transceiver or microphone has been dropped, waterproof
protection cannot be guaranteed because of possible damage to
the transceiver's or microphone's case or the waterproof seal.
* Equivalent to IPX8
Icom is not responsible for the destruction or damage to the
Icom transceiver, if the malfunction is because of:
• Force majeure, including, but not limited to, fires,
earthquakes, storms, floods, lightning, other natural
disasters, disturbances, riots, war, or radioactive
contamination.
• The use of Icom transceivers with any equipment that is not
manufactured or approved by Icom.
™ employ waterproof

Advertisement

Table of Contents
loading

Table of Contents