Multiple Calypso Fixtures (Master/Slave Mode) - SHOWTEC Calypso 43104 User Manual

Multiple Calypso fixtures (Master/Slave Mode)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Make sure the powercables off all calypso fixtures are unplugged.
3. Use a 3-p XLR cable to connect the Calypso.
The pins:
4. Link the units as shown in (Fig. 3); connect a DMX signal cable from the first unit's "SLAVE OUT" socket
to the second unit's "IN" socket. Connect a DMX signal cable from the second unit's "OUT" socket to
the third unit's "IN "socket. Repeat this process to link the third unit, fourth unit etc.
same functions on the master device as described on the former page (Single Calypso (music
control). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
5. Set up the master unit. Make sure that address DIP switches 1-9 are all set in OFF position.
Address = zero (No DMX control).
Use the F1 DIP switch to setup a fixture as master.
F1: OFF = master
F2: Allows you to set up for synchronous or asynchronous pattern.
OFF: Asynchronous (4 light show) pattern.
ON: Synchronous pattern.
More info will be given in step 7.
6. Set up the slave unit.
F1: ON = slave
F2: Has no function for slave units.
7. The master fixture can be set up in two modes:
A. Synchronous pattern
B. Asynchronous pattern (4 light show)
1. Earth
2. Signal -
3. Signal +
Multiple Calypso fixtures (Master/Slave control)
10
You can use the
Fig. 3