Overview; Installation; Set Up And Operation - SHOWTEC Calypso 43104 User Manual

Overview

1) Mountingbracket with adjustment screws for Truss mounting
2) Fixed power cable with Schuko plug
3) Fuse (T1A)
4) DMX signal connector (IN) 3-pin
5) Microphone
6) DMX address DIP switch 1-9
Allows you to set up the fixture's DMX address. The unit is in stand-alone mode when all dipswitches
are off.
7) Function DIP switch F1 and F2
F1: master (off)/ slave (on)
F2: synchronous (off) / asynchronous (on) pattern
8) DMX signal connector (SLAVE OUT) 3-pin
9) DMX signal connector (OUT) 3-pin

Installation

Remove all packing materials from the Calypso. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
8
Fig. 2