Studer SW V4.0 OnAir 1000 Operating And Service Instructions page 98

OnAir 1000 Digital Mixing Console
Set User Channel Routing:
10-6 User Modes
sired name, and then reload the snapshots, mic settings, and channel rout-
ing from the card. After touching SAVE, the old record is replaced by the
new one. This procedure has to be performed this way in order to avoid
name conflicts in the console's memory and on the PC-card.
When editing the default user, the USER EDIT page looks similar, except
that no password field is displayed.
When editing the administrator, the USER EDIT page neither displays the
access permission fields nor the USER NAME field, but the password
field is enabled.
The system administrator can define the user channel routing (surface
definition) for every user by touching the SET CHANNEL ROUTING
field in the USER EDIT page. In addition, the administrator can allow a
user to change his own channel routing.
When the SET CHANNEL ROUTING field is touched, the CHANNEL
ROUTING page appears and displays this specific user's channel routing.
Instead of the SAVE TO USER PROFILE field, a BACK field is dis-
played, leading back to the USER EDIT page.
The system administrator can protect specific connections within the
channel routing by selecting the desired cross-point with the horizontal and
vertical lines, and then touching the PROT(ect) field. A protected connec-
tion is indicated by a dashed vertical line in the grid (see below); this con-
nection cannot be changed by the user, even if he might be allowed to
change his channel routing. Only the administrator can UNPROT(ect) this
connection again. However, the user can change the input selection (A/B)
of this input unit, if he has the INPUT SEL access right.
SW V 4.0 Date printed: 23.10.03