Studer SW V4.0 OnAir 1000 Operating And Service Instructions page 32

OnAir 1000 Digital Mixing Console
Analog Outputs
D/A converter
Frequency response
Output impedance
Digital Outputs
Output impedance
Equalizer Treble control (High)
Equalizer (Mid)
Bass control (Low)
Crosstalk Attenuation
Between channels
Input fader attenuation
Power Supply
Mains voltage
Power consumption
DC operation
2-4 General
Analog outputs are transformer-balanced with XLR connectors.
Output level +4 to +24 dBu @ R
+4 to +23 dBu @ R
24 bit (Delta-Sigma, 128 × oversampling)
Dynamics typ. 101 dB (unweighted)
THD+N < –90 dB
FS
±0.2 dB
< 40 Ω
Digital outputs are equipped with two independent outputs according to the
AES/EBU standard (AES3-1992). On each of these outputs, the same signal is fed
to two XLR sockets with individual buffers.
Output level 2 to 5 V
110 Ω
5 kHz/10 kHz: ±15 dB (depending on Customer Code setting; refer to
200 Hz to 10 kHz: ±15 dB
200 Hz/400 Hz: ±15 dB
> 90 dB
> 100 dB
Redundant power supply available on request.
100 to 240 V, 50/60 Hz (auto-ranging)
130 VA typ.
24 V +15/–10 %; typ. 5 A @ 24
DC
Note: The abovementioned values are typical values; in an individual case, the
values may differ. We reserve the right to make changes as technological
progress may warrant.
SW V 4.0
= 100 kΩ;
L
= 300 Ω
L
@ 1 kHz, –1 dB
FS
V
11.2.11
)
Date printed: 23.10.03