For Consoles with Serial No. 1281 and below:
Date printed: 27.10.03
•
Repeat this procedure for each of the four output connectors of each of the
three Analog Output Units.
Notes:
Please consider that maximum undistorted level of the analog outputs is
+23 dBu (@ 0 dB
not exceed a value of +14 dBu (with an input signal of –9 dB
ering the standard headroom margin of 9 dB.
Once finished, don't forget to re-establish the console settings as they
were before the alignment procedure.
•
Select the Channel Control page (e.g. "I 9A"): Touch HOME and press the
SEL key of the corresponding channel. Perform the following settings on
the Channel Control page:
MODE: ST (stereo), LR (normal stereo mode)
PHASE: NORM
CAL: 0 dB
Routing: to the PGM and REC outputs; the ΣPROGRAM and ΣRECORD
touch-screen fields must be highlighted.
BAL: center position.
•
Switch the equalizer off by pressing the EQ key if it is illuminated.
•
Switch the console off.
•
Open the console according to
nected so that the console remains operative.
•
Remove the Analog Output Unit to be aligned (refer to
re-connect it to connector P71 of the DSP board using the 64pin extension
cable 1.942.500.26. Reconnect the daisy-chain flat cable of the Output
Module Bus to the extension cable. Now the Analog Output Unit can be
placed in front of the console on an insulating sheet, e.g. a piece of card-
board. Put down the console front cover, but don't fix it with its screws.
•
Set the jumpers of the Analog Output Unit temporarily to RECORD (for
the lower/"B" output connectors) and to PGM (for the upper/"A" output
connectors), select STEREO for both outputs A and B; refer to the illus-
tration on the following page.
•
Switch the console on again.
•
Switch the corresponding channel ON, and set its channel fader as well as
the PGM and REC faders to their 0 dB position.
•
Connect an analog audio level meter to one of the PCB's output connec-
tors.
•
Align for a reading of your desired nominal level (default factory setting:
+6 dBu) on the audio level meter; select the corresponding trimmer poten-
tiometer according to the table below.
PGM/A, right
•
Repeat this procedure for each of the four output connectors of each of the
three Analog Output Units.
Note:
Please consider that maximum undistorted level of the analog outputs is
+23 dBu (@ 0 dB
not exceed a value of +14 dBu (with an input signal of –9 dB
ering the standard headroom margin of 9 dB.
SW V4.0
OnAir 1000 Digital Mixing Console
) into a 300 Ω load. When setting the output levels, do
FS
chapter
Output:
PGM/A, left
REC/B, right
REC/B, left
) into a 300 Ω load. When setting the output levels, do
FS
4.1, but leave the front cover con-
chapter
Align with:
RA1
RA2
RA3
RA4
Service 4-7
), consid-
FS
4.2.1) and
), consid-
FS