Studer SW V4.0 OnAir 1000 Operating And Service Instructions page 18

OnAir 1000 Digital Mixing Console
5 Additional Customer Codes
Code 0x00000800:
Code 0x00001000:
Code 0x00002000:
Code 0x00004000:
Code 0x00008000:
4 New Features
Used to disable dimming of the CR monitor speakers during talkback from
the studio to the control room.
Used to disable dimming of the studio monitor speakers during talkback
from the control room to the studio.
Used to swap the functions of the PFL and the OFF keys next to the faders,
regardless whether they are used for the standard PFL and OFF functions,
or whether other functions are configured for any of these keys.
Basic information on this subject to be found in chapter 9
If this code is active, whenever a channel is activated by moving its fader up
from its lower stop while it is switched ON (or the other way round, by
switching the channel ON while its fader is positioned above the lower stop),
this channel's Channel Control page pops up automatically and allows for
immediate changes of the channel settings. This Channel Control page re-
mains displayed until another channel is activated, or until another page is
selected using one of the five buttons next to the clock dial.
If this code is active, the status of the channel ON/OFF switch of channels
currently not routed to the console surface will be saved in the flash memory
when powering the console off. At power on, the ON or OFF status of these
channels will automatically be re-established.
If this code is inactive, the channels not routed to the console surface will
always be set to OFF at power on.
Basic information on Customer Code to be found in chapter 11.2.11
SW V 4.02/V4.03 Date printed: 12.07.04