Studer SW V4.0 OnAir 1000 Operating And Service Instructions page 17

4 Additional REC Signaling Output
Date printed: 12.07.04
However, no Monitor Extension module can be installed in an OnAir 1000
console, which means that no other functions (as known from OnAir
2000M2 consoles) can be configured.
An additional REC signaling output has been provided on pin 9 of the
SIGN. connector (formerly labeled as "Spare OUT") to extend the on-air
signaling features.
SIGN. (D-type, 9 pin, male):
Pin Signal
5
1 +5 V SUPPLY
9
4
2 ON AIR IN –
8
3
7
3 CR MIC OUT
2
6
4 PGM OUT
1
5 GND
For the ON AIR INDICATION setting on the COMMON SETTINGS
page, a fourth selection item (ΣPROGRAM/ΣREC) was created. Depending
on this setting, the two signaling outputs are active according to the follow-
ing table:
ON AIR
INDICATION
setting
1)
ΣPROGRAM
AND ΣREC
2)
ΣPROGRAM
3)
ΣREC
4)
ΣPROGRAM
/ ΣREC
(new setting)
In other words:
st
• For the 1
signal is routed either to the program or the record output (or both).
nd
• For the 2
audio signal is routed to the program output. An audio signal routed to the
record output has no effect.
rd
• For the 3
audio signal is routed to the record output. An audio signal routed to the
program output has no effect.
th
• For the 4
while an audio signal is routed to the program output, and only the REC
OUT signaling output is active while an audio signal is routed to the record
output. If audio signals are routed to both the program and the record out-
puts, both the PGM OUT and REC OUT signaling outputs are active.
Basic information on this subject to be found in chapter 11.2.2
SW V 4.02/V4.03
OnAir 1000 Digital Mixing Console
PROGRAM
output on-air output on-air
0
1
0
1
0
1
x
x
0
1
0
1
setting, both signaling outputs are active whenever any audio
setting, only the PGM OUT signaling output is active while an
setting, only the REC OUT signaling output is active while an
(new) setting, only the PGM OUT signaling output is active
Pin Signal
6 COMMON
7 Spare IN – or Ext. CR DIM IN – *
8 STUDIO MIC OUT
9 REC OUT
* depending on Customer Code setting
SIGN output:
REC
Pin 4
(PGM OUT)
0 0
0 1
1 1
1 1
x 0
x 1
0 0
1 0
0 0
0 1
1 0
1 1
New Features 3
Pin 9
(REC OUT)
(new output)
0
1
1
1
0
0
0
1
0
0
1
1