Studer SW V4.0 OnAir 1000 Operating And Service Instructions page 62

OnAir 1000 Digital Mixing Console
Making a Crosspoint
Temporary Routing
Permanent Routing
Clearing a Crosspoint
Protected Connections
5-12 Master Functions
The program and record master fader assignment is fixed (PGM MASTER
to fader no. 11, REC MASTER to fader no. 12). These two faders can be
disabled (CLEAR) and re-enabled (SET), but not re-assigned to input
channels. They are located at the far right of the grid ("P" and "R"). An
example of this particular CHANNEL ROUTING page is shown below:
On the left part of the CHANNEL ROUTING page, the input unit-to-fader
strip assignment is performed with the two left rotary encoders below the
touch-screen. When turning these encoders, the highlighted horizontal and
vertical lines are moved within the grid. The input channel and fader num-
bers are displayed above the two rotary encoders, as well as the type of the
selected input unit (MIC/ANALOG/DIGITAL) and the position of the cur-
rently selected fader.
Above the input unit-to-fader strip assignment, the input labels are dis-
played.
The channel routing relates to the physical input. This means that, for ex-
ample, input B can be selected; when loading this set-up later, input B with
all its input parameters (as input gain, EQ settings, etc.) is automatically
selected. These parameters are input-related and will be automatically re-
routed when the input channel is assigned to a different fader.
When the desired crosspoint is found, touch the SET field. A dot appears
at this crosspoint in the grid, indicating the established connection.
The fader to which this input channel had been assigned before is free
now, and its dot jumps outside the grid to the left (fader 07 in the picture
above). The same happens when the CLEAR field is touched after having
selected a connection.
When all settings are done, touch the APPLY field. The new channel
routing is loaded to the work memory. There are two ways to proceed now:
When touching the EXIT field, the page is left without saving, and the user
can work with the new channel routing.
However, the new routing is not stored in the user's profile. When the user
logs out, the temporary channel routing is lost, and his original channel
routing will be loaded when logging in the next time.
To store the new channel routing within the user's profile, the SAVE TO
USER PROFILE field has to be touched before exiting the page with
EXIT.
When the CLEAR field is touched after having selected a connection, then
this fader strip is free now, and its dot jumps outside the grid to the left.
One or several connections can be protected by the administrator from
being modified, even by users having access permission to the CHANNEL
SW V 4.0 Date printed: 23.10.03