Studer SW V4.0 OnAir 1000 Operating And Service Instructions page 45

INS1 / INS2:
AUTO TAKEOVER Arrow LEDs: After having modified the channel routing or during radio automation
Date printed: 23.10.03
fader), "PF" (pre-fader), "ON" or "OFF". These touch-screen fields are
highlighted if selected.
The INS1 or the INS2 LED is on if the respective input channel's signal is
INS1
routed trough one of the analog inserts 1 or 2. The inserts are controlled in
INS2 the AUX MASTER/INSERTS page on the touch-screen.
(CAB) operation, they indicate that the fader has to be moved up-
ward/downward to match the physical and the logical positions.
AUTO
If the console is used together with an automation system, the fader value
TAKE
OVER
can be set by the automation system via the "Monitora" protocol. In case
the user would like to take-over the control of the signal with the fader, the
AUTO TAKEOVER arrow LED(s) of the input channels being controlled
by the automation system indicate in which direction the fader has to be
moved to match its physical and its logical position. If the positions are
matched, or if, by chance, the fader is in the exact position, both arrow
LEDs remain illuminated as long as this input channel is on air.
If an input channel is currently on air, its label continuously scrolls by in
the channel label display.
AUTO
TAKE
OVER
Channels not con-
trolled by a CAB
system
SW V 4.0
OnAir 1000 Digital Mixing Console
AUTO
TAKE
OVER
Audio level above Audio level below
the fader position – the fader position –
move fader down move fader up
AUTO AUTO
TAKE TAKE
OVER OVER
Audio level
equal to the
fader position
Channel Functions 4-3