Exit Without Saving; System Error Report - DFI G586IPV User Manual

Type " Y" and press <Enter>. The modifications you have made will be
written into the CMOS memory, and the system will reboot. You will
once again see the initial diagnostics on the screen. If you wish to
make additional changes to the setup, press <Ctrl> <Alt> <Esc> simul-
taneously or <Del> after memory testing is done.

Exit Without Saving

When you do not want to save the changes you have made, highlight " Exit
Without Saving" and press <Enter>. The message below will appear:
Quit Without Saving (Y/N)? N
Type " Y" and press <Enter>. The system will reboot and you will once
again see the initial diagnostics on the screen. If you wish to make any
changes to the setup, press <Ctrl> <Alt> <Esc> simultaneously or
<Del> after memory testing is done.

System Error Report

When the BIOS encounters an error that requires the user to correct
something, either a beep code will sound or a message will be dis-
played in a box in the middle of the screen and the message PRESS
F1 TO CONTINUE, CTRL-ALT-ESC or DEL TO ENTER SETUP, will be
shown in the information box at the bottom. Enter Setup to correct the
error.
POST Beep
There is one beep code in the BIOS. This code indicates that a video
error has occurred and the BIOS cannot initialize the video screen to
display any additional information. This beep code consists of a single
long beep followed by two short beeps. If you get this error, contact
your system board vendor.
63