DFI G586IPV User Manual page 33

2. Install the other 40-pin header connector(s) into the device with the
colored edge of the ribbon cable aligned with pin 1 of the drive
edge connector (s).
Note:
Refer to your disk drive user' s manual for information about selecting
proper drive switch settings.
Adding a Second IDE Hard Drive
When using two IDE drives, one must be set as the master and the
other as the slave. Follow the instructions provided by the drive manu-
facturer for setting the jumpers and/or switches on the drives.
We recommend that the Enhanced IDE hard drives be from the same
manufacturer. In a few cases, drives from two different manufacturers
will not function properly when used together. The problem lies in the
hard drives, not the G586IPV system board.
Preparing an IDE Drive for Use
IDE disk drives are already low-level formatted, with any bad-track er-
rors entered, when shipped by the drive manufacturer. Do not attempt to
do a low-level format or you may cause serious damage to the drive. To
use an IDE drive, you need to enter the drive type (this information is
provided by the drive manufacturer) into the system' s CMOS setup
table. You also can use the " IDE Auto Detection" to set your IDE Drive
mode, please refer to the relevant information on the section " IDE Auto
Detection" .
Warning:
Do not run FDISK and FORMAT programs on a drive that has already
been formatted or you will lose all programs and data stored on the
drive.
32