DFI G586IPV User Manual page 65

Error Messages
One or more of the following messages may be displayed if the BIOS
detects an error during the POST.
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. Insert a system disk into Drive A and press
<Enter>. If the system normally boots from the hard drive, make sure
the controller is inserted correctly and all cables are properly attached.
Also be sure the disk is formatted as a boot device. Reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUP
The type of diskette drive installed in the system is different from the
CMOS definition. Run setup to reconfigure the drive type correctly.
DISPLAY SWITCH IS SET INCORRECTLY
The display switch on the system board can be set to either mono-
chrome or color. This error indicates the switch is set to a different
setting than indicated in Setup. Determine which setting is correct and
either turn off the system and change the jumper or enter Setup and
change the Video selection.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter has been
changed. You must configure the system for the new display type.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
The hard drive cannot be initialized. Be sure the adapter is installed
correctly and all cables are correctly and firmly attached. Also, be sure
the correct hard drive type is selected in Setup.
ERROR INITIALIZING HARD DISK CONTROLLER
The system cannot initialize the controller. Make sure the card is cor-
rectly and firmly installed in the bus. Be sure the correct hard drive type
is selected in Setup. Also, check to see if any jumper needs to be set
correctly on the hard drive.
64