DFI G586IPV User Manual page 57

FDD Controller used.
Enabled
Disabled FDD Controller not used.
Onboard Serial Port 1 or 2
This option allows you to control the assignment of the serial port 1 or 2
connector on the system board. The default value of port 1 is 3F8/IRQ4,
and that of port 2 is 2F8/IRQ3.
Disabled When disabled, you cannot set the assignment of the serial
port.
3F8/IRQ4 This option allows you to control the assignment of the serial
2F8/IRQ3 port 1 or 2 connector on the system board.
3E8/IRQ4
2E8/IRQ3
UART 2 Mode
This item allows you to use IrDA function. The default value is Standard.
Standard If you are using the COM 2 serial port.
HPSIR If you are using IrDA that is an HP standard.
ASKIR If you are using IrDA that is a SHARP standard.
Onbard Parallel Port
The default value is 378H/IRQ7.
When disabled, you cannot select the address and IRQs of
Disabled
the onboard parallel port.
This option allows you to select different addresses and
278H/IRQ5
IRQs the onboard parallel port.
378H/IRQ7
3BC/IRQ7
56