DFI G586IPV User Manual page 49

N o The System BIOS will ignore Advanced Power Management
(APM) when initiating the power management mode.
Note: If the APM is not installed, this option has no effect.
Video Off Method
This determines the manner in which the monitor is blanked. The default
value is V/H SYNC + Blank.
V/H This selection will cause the system to turn off the vertical
SYNC+ and horizontal synchronization ports and write blanks to the
Blank video buffer.
Note: After detecting the V/H SYNC signals, an energy sav-
ing monitor will turn off its table.
Blank This option only writes blanks to the video buffer.
Screen
DPMS This option should be enabled only for VGA cards supporting
DPMS. Initial Display Power Management Signaling.
Standby Mode
When enabled and after the set time of the system inactivity, the fixed
disk drive and the video would be shut off while all other devices still
operate at full speed. The default value is Disabled.
Disabled This function cannot be executed.
1Min-1Hr The Standby mode will be set to one minute.
This option defines the idle time that elapses before the sys-
tem enters Standby mode.
48