Appendix F: Row Address Of The Dram And Sdram - DFI G586IPV User Manual

Row Address Strobe of the DRAM and SDRAM
After you power up your system, the BIOS message appears on your
screen and the memory count begins.
After the memory test, the screen will appear as below:
CPU Type :6x86-P166+
Co-Processor :Installed
CPU Clock :133MHz
Diskette Drive A :1.44M, 3.5in.
Diskette Drive B :None
Pri. Master Disk :None
Pri. Slave Disk :None
Sec. Master Disk :None
Sec. Slave Disk :None
EDO DRAM at Row (s)
"Row (s)" refers to the Row Address Strobe of the DRAM or SDRAM.
The Row Address Strobe differs according to the location and type of
DRAM or SDRAM installed on the system board. The table below shows
the Row Address Strobe values with their corresponding type of SIM/
DIM modules and Bank locations.
Number/Location of
"Rows"
SIM or DIM modules
0 2 SIMM / Bank 0
0, 1 2 SIMM / Bank 0
0, 2
4 SIMM / Bank 0, 1
0, 1, 2, 3 4 SIMM / Bank 0, 1
2
1 DIMM / DM1
2, 3 1 DIMM / DM1
Award Software, Inc.
System Configurations
Base Memory
Extended Memory
Cache Memory
Display Type
Serial Port (s)
Parallel Port (s)
EDO DRAM at Row (s)
SDRAM at Row (s)
PB SRAM Presence
Types of SIM/DIM module
( Single/Double Density)
Single density EDO DRAM
Double density EDO DRAM
Single density EDO DRAM
Double density EDO DRAM
Single density SDRAM
Double density SDRAM
Appendix F
:640K
:15360K
:256K
:EGA/VGA
:3F8 2F8
:378
: 0, 1
:None
:Yes
81