DFI G586IPV User Manual page 14

1. Unlock your system unit. Turn off the power and disconnect all
power cords and cables.
2. Remove the system unit cover. Refer to the manufacturer' s instruc-
tions if necessary.
3. Detach all connectors from the old system board and remove ex-
pansion cards seated in any expansion slots.
4. Loosen the screws holding the original system board and remove
the board from the system. Save the screws.
5. Remove the G586IPV from its original packing box. Be careful to
avoid touching all connectors and pins on the board. Please refer to
the handling instructions on pages 11-12 for proper handling tech-
niques.
6. Insert the memory modules into the memory banks on the
G586IPV. The quantity and location of the memory modules de-
pends on the memory configuration and type of modules you intend
to use.
7. Insert the cache module, if any, into the cache module slot on the
G586IPV. Refer to the Cache Memory section on page 18 for up-
grading your cache memory.
8. Install the CPU. Be sure pin 1 of the CPU is aligned with pin 1 of
the socket.
9. Set the corresponding jumpers.
10. Install the prepared G586IPV system board into the case and re-
place the screws.
11.
Reinstall all cards and connectors and replace the system unit
cover. Reconnect all power cords and cables.
13