Jumper Settings For Dimm And Simm - DFI G586IPV User Manual

Installing a SIM Module
A SIM module simply snaps into a socket on the system board. Pin 1 of
the SIM module must correspond with Pin 1 of the socket .
1. Position the SIMM above the socket with the " notch" in the module
aligned with the " key" on the socket.
2. Seat the module at a 45° angle into the bank. Make sure it is com-
pletely seated. Tilt the module upright until it locks in place in the
socket.
Warning:
The DIMM and SIMM can not exist on the G586IPV system board at
the same time. You must only use either a DIMM or SIMMs on your
system board.

Jumper Settings for DIMM and SIMM

Jumper JP10
DIMM and SIMM Select
Jumper JP10 must match the type of module installed on the G586IPV
system board. If you change your memory module, make sure this
jumper is changed accordingly.
notch
key
17