Supervisor Password - DFI G586IPV User Manual

Parallel Port Mode
The default value is SPP.
SPP This function is the mode of the device. Set this according
EPP/SPP your parallel devices.
ECP
ECP/EPP

Supervisor Password

If you want to protect your system and setup from unauthorized entry,
set a supervisor' s password with the " System" option selected in the
BIOS Features Setup.
If you want to protect access to setup only, but not your system, set a
supervisor' s password with the " Setup" option selected in the BIOS
Features Setup. You will not be prompted for a password when you
cold boot the system.
Use the arrow keys to highlight the " Supervisor Password" option and
press <Enter>. The message below will appear.
Enter Password:
Type in the password. You are limited to eight characters. When done,
the message below will appear:
Confirm Password:
You are asked to verify the password. Type in exactly the same pass-
word. If you type in a wrong password, you will be prompted to enter
the correct password again.
57