Light Snoot; Installing The Light Snoot (Exploded View - High End Systems studio color User Manual

Light Snoot

Studio Color has an optional light snoot which can be installed to eliminate the
light leak common with Fresnel lenses.
To complete this procedure, you will need the following items:
• light snoot
• phillips screw driver
Complete the following procedure to install the light snoot:
1. Remove power from the fixture and place it on a flat surface.
2. Remove the bezel by releasing the two latches located in the middle of the
3. Remove the safety cable from its latch and set the bezel on a flat surface.
4. Using a phillips-head screw driver, loosen the four screws securing the clips to
5. Remove the lens and set it aside.
6. Place the light snoot under the four securing clips with the lip pointing
B-8 Studio Color User's Manual
head. Refer to Figure B.1.
the lens and rotate the clips 90°. Refer to Figure B.7.
outwards and replace the lens. Refer to Figure B.8.
Figure B.8. Installing the Light Snoot (Exploded View)