Terminator Construction - High End Systems studio color User Manual

Terminator Construction

DMX-512 protocol recommends terminating resistors be used on the last
fixture on the link. You will need the following items to construct a
terminator:
• Male three-pin XLR connector
120 Ω resistor (¼ watt minimum)
•
To construct a terminator, complete the following procedure:
1. Disassemble the male XLR connector.
2. Solder a 120 Ω resistor, minimum of ¼ watt, between pins 2 and 3.
3. Reassemble the XLR connector.
1-6 Studio Color User's Manual
2
1
3
Figure 1.4. Terminator Construction