Data Cabling - High End Systems studio color User Manual

Data Cabling

To connect the data cables, complete the following procedure:
1. Connect the data cable from the controller to the
of the fixture. Refer to Figure 1.10.
Figure 1.10. Data In and Data Out Connectors
2. Daisy chain additional fixtures by connecting the
connectors on subsequent fixtures. Refer to Figure 1.11.
Data In
to additional
fixtures
3. Install a terminator in the
link.
4. Connect AC mains (power) and turn on the breaker located next to the power
cord on the side of each fixture. Refer to Figure 1.10.
5. The fixture(s) will home and run through a built in self-test.
Note: if any error messages are present on the display, refer to Troubleshooting in
Appendix A.
DA TA OU T DA TA I N
P O WER
Figure 1.11. Daisy Chaining Fixtures
connector of the last fixture on each DMX
Data Out
connector on the side
Data In
connector to the
Data Out
DMX controller
DA TA OU T DA TA I N
DAT A L INK
OU T
M ID I ANA L OG INPUT S
S E RIA L P OR T IN OUT 1-6
PE RS ON A LIT Y M A S TER S LA V E
A RS - 232
PO WER B
1 2 3 4 1 2 3 4 5 6 7 8
Chapter 1 Installation and Setup 1-11
L
R
S T E R E O
7-12 AU DI O CA UT IO N
IN P U T F US E v o l t a ge
RE M OT E 1. 6 a mp s e l ect
E NA B LE