Road Cases; Minimum Material Requirements; Construction Requirements; Road Case Construction Overhead View - High End Systems studio color User Manual

Road Cases

If Studio Color fixtures will be transported after they are unpacked from their
original shipping box, a professional road case is strongly recommended. Road
cases must be purchased from High End Systems or constructed according to
the information in this section.

Minimum Material Requirements

Use the following materials to construct the road case:
•
•
•

Construction Requirements

The road case must be constructed in a manner that supports the base and the
handles with the head pointed down and the yoke rotated 90°. Refer to Figure 1.1
and Figure 1.2.
Caution: For 575-S fixtures, allow a small gap in the foam around the heat sink to
1-2 Studio Color User's Manual
3/4-inch pressed plywood
4 pound poly-ethylene foam
steel or aluminum rivets
ensure that the foam is not damaged by the heat from the fixture.
foam
Figure 1.1. Road Case Construction Overhead View
case exterior
fixture base