Setting The Starting Channel By Dmx Channel Number - High End Systems studio color User Manual

Setting the Starting Channel by DMX Channel Number

To set the starting channel by DMX channel number, complete the following
procedure:
Caution: if an incorrect starting channel is given, channels could overlap and produce
unexpected results.
1. Apply power to the fixture.
2. Observe the display on the front of the fixture. Initially, it will display the
software version (
3. Press and hold the <
Refer to Figure 1.12.
4. Use the up and down keys to move to the
enter the
S E T
5. Use the up and down keys to move to the
enter the
C H N L
6. Use the up and down keys to move to the
enable the fixture to accept addressing by DMX channel.
7. Press the <
MENU
8. Using the up and down keys on the front of the unit, set an the starting
channel from (
channels per fixture. Refer to Table 1.2 "DMX Starting Channel" on page
1-14 for assistance. The display will flash when it is moved from the stored
value.
9. Press the <
ENTER
display will stop flashing. The fixture address is stored in ROM and retains
its value until the value is changed.
Note: if < > is not pressed, the unit will not store the starting channel.
ENTER
10. Press and hold the <
) and then the fixture number (
V x x x
> button until the display changes to
MENU
field.
field.
> key to back out to the
to ). Studio Color fixtures require 16 DMX
C 0 0 1 C 5 1 2
> key to store the appropriate starting channel. The
> button to exit the menu.
MENU
).
F 0 1
A d d R
field. Press <
S E T
ENTER
field. Press <
C H N L
ENTER
field. Press <
D M X ENTER
(address) field.
A d d R
Chapter 1 Installation and Setup 1-13
.
> to
> to
> to