IBM x3650 M3 Installation And User Manual page 140

Figure 127. Power-supply connectors
Figure 128. Power information label
10. (IBM Business Partners only) Complete the additional steps in "Instructions
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 154.
126
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
The following illustration shows the ac power-supply connectors on the rear
of the server.
5. Route the power cord through the power-supply handle and through any
cable clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you slide the server in and out of the rack.
6. Connect the power cord to a properly grounded electrical outlet.
7. Make sure that the ac power LED and the dc power LED on the ac power
supply are lit, indicating that the power supply is operating correctly. The two
green LEDs are to the right of the power-cord connector.
8. If you are replacing a power supply with one of a different wattage, apply the
power information label provided with the new power supply over the
existing power information label on the server.
x.x/x.x
xx/xx HZ
9. (IBM Business Partners only) Restart the server. Confirm that it starts correctly
and recognizes the newly installed devices, and make sure that no error LEDs
are lit.
for IBM Business Partners" on page 26.