Figure 62. 4-drive filler panels removal
5. To obtain more working room, remove fans 2 and 3 (see "Removing a
hot-swap fan" on page 127).
6. Pull the hard disk drives or fillers out of the server slightly to disengage them
from the backplanes. For more information, see"Removing a hard disk drive"
on page 62.
7. Disconnect the SAS signal cables from the SAS controller, which is connected
to the SAS riser-card. Leave the other end of the SAS signal cables connected
to the hard disk drive backplanes.
Figure 63. Disconnecting SAS signal cables
8. Remove the SAS controller assembly from the server; then, remove the SAS
controller from the SAS riser-card. See "Removing a ServeRAID SAS controller
from the SAS riser-card" on page 134 for instructions.
Chapter 2. Installing optional devices
73