Power-Supply Leds - IBM x3650 M3 Installation And User Manual

Types 4255, 7945, and 7949
Hide thumbs Also See for x3650 M3:
Table of Contents

Advertisement

System-error LED: When this LED is lit, it indicates that a system error has
occurred. An LED on the light path diagnostics panel is also lit to help isolate the
error. This LED is the same as the system-error LED on the front of the server.
Locator LED: Use this LED to visually locate the server among other servers. You
can use IBM Systems Director to light this LED remotely. This LED is the same as
the system-locator LED on the front of the server.
Power-on LED: Press this button to turn the server on and off manually or to
wake the server from a reduced-power state. The states of the power-on LED are
as follows:
v Off: AC power is not present, or the power supply or the LED itself has failed.
v Flashing rapidly (4 times per second): The server is turned off and is not ready
v Flashing slowly (once per second): The server is turned off and is ready to be
v Lit: The server is turned on.
v Fading on and off: The server is in a reduced-power state. To wake the server,

Power-supply LEDs

The following illustration shows the power-supply LEDs on the rear of the server.
For more information about solving power-supply problems, see the Problem
Determination and Service Guide.
Figure 11. Power-supply LEDs rear view
The following table describes the problems that are indicated by various
combinations of the power-supply LEDs and the power-on LED on the operator
information panel and suggested actions to correct the detected problems.
20
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
to be turned on. The power-control button is disabled. This will last
approximately 20 to 40 seconds.
Note: Approximately 40 seconds after the server is connected to ac power, the
power-control button becomes active.
turned on. You can press the power-control button to turn on the server.
press the power-control button or use the IMM Web interface. For information
about logging on to the IMM Web interface, see "Logging on to the Web
interface" on page 171.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents