IBM x3650 M3 Installation And User Manual page 126

Microprocessor
cover release
tabs
Figure 114. Installation tool cover removal
Alignment pins
Figure 115. Installation tool alignment
112
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
h. Remove the cover from the bottom of the microprocessor installation tool.
Press both microprocessor cover release tabs outward (in opposite
directions as shown in the illustration) and remove the microprocessor
installation tool with the microprocessor attached.
Installation tool
Microprocessor
cover
i. Carefully align the microprocessor installation tool over the microprocessor
socket.
Attention: The microprocessor fits only one way on the socket. You must
place a microprocessor straight down on the socket to avoid damaging the
pins on the socket. The pins on the socket are fragile. Any damage to the
pins may require replacing the system board.
j. Twist the handle on the microprocessor tool counterclockwise to insert the
microprocessor into the socket.
Microprocessor
Installation tool
Microprocessor