IBM x3650 M3 Installation And User Manual page 98

22. If required, connect one end of the remote battery cable to the interposer card.
Figure 79. Connecting remote battery cable
23. Connect the shorter SAS signal cable that comes with the option kit to the
Figure 80. Connecting SAS signal cable
84
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
c. From the front side of the SAS controller, install the two screws that hold
the metal bracket onto the SAS controller.
Attention: To avoid damage to the hardware, make sure that you align the
black dot on the cable connector with the black dot on the connector on the
interposer card. Do not force the remote battery cable into the connector.
SAS controller connector that is labeled "Ports 7-4"
Note: