Installing A Pci Adapter - IBM x3650 M3 Installation And User Manual

Figure 38. Full-length-adapter bracket removal
To remove and store the full-length-adapter bracket, complete the following steps:
1. Press the bracket tab 3 and slide the bracket to the left until the bracket falls
2. Align the bracket with the storage location on the riser-card assembly as
3. Place the two hooks 1 in the two openings 2 in the storage location on the
4. Press the bracket tab 3 and slide the bracket toward the expansion-slot-
5. Return to "Installing a PCI adapter" or "Installing a PCI riser-card assembly"

Installing a PCI adapter

Use this information to install a PCI adapter.
About this task
The following illustration shows the PCI adapter expansion slots from the rear of
the server.
Figure 39. PCI adapter expansion slots
The following notes describe the types of adapters that the server supports and
other information that you must consider when you install an adapter:
v Locate the documentation that comes with the adapter and follow those
v To ensure that a ServeRAID-10i, ServeRAID-10is, or ServeRAID-10M adapter
free of the riser-card assembly.
shown.
riser-card assembly.
opening end of the assembly until the bracket clicks into place.
on page 47, as applicable.
instruction in addition to the instructions in this section. If you have to change
switch settings or jumper settings on the adapter, follow the instructions that
come with the adapter.
works correctly in your UEFI-based server, make sure that the adapter firmware
is at the latest level.
Chapter 2. Installing optional devices
53