Access Control - Digisol DG-BG1100U User Manual

4.6.5 Access Control

Access Control – Services
Select "Access Control"-->"Services" to show the following interface. In the
interface, you can enable/disable the FTP, HTTP, ICMP, SNMP, TELNET and TFTP
services. And the LAN side and WAN side show different configurations.
Note: The WAN information is not displayed in the bridge mode.
Access Control – IP Addresses
Choose Access Control > IP Addresses and the following page appears.
In this page, you can add or remove the IP address in the IP access control list.
If the Access Control Mode is enabled, it indicates that the router permits the access to
local management services from the IP addresses contained in the access control list.
If the Access Control Mode is disabled, the system does not validate IP addresses for
the incoming packets.
DG-BG1100U User Manual
77