Adding An Ipoa Pvc - Digisol DG-BG1100U User Manual

Enable NAT: Select it to enable the NAT functions of the router. If you do not want to
enable NAT and wish the router user to access the Internet normally, you must add a
route on the uplink equipment. Otherwise, the access to the Internet fails. Normally,
NAT should be enabled.
Enable Fullcone NAT: A full cone NAT is one where all requests from the same
internal IP address and port are mapped to the same external IP address and port.
Furthermore, any external host can send a packet to the internal host, by sending a
packet to the mapped external address.
Enable Firewall: Enable or disable IP filtering.
IGMP Multicast: IGMP proxy. For example, if you wish that the MER mode supports
IPTV, enable this function.
WAN Service: Enable it, unless you do not want to active the PVC.
Click Next and the following page appears. This page shows all the configuration.
To save the settings, click Save. To make any modifications, click Back.
Note: You need to reboot the router to activate this WAN interface and further
configure services in this interface.

4.4.1.4 Adding an IPoA PVC

This section describes the procedure for adding PVC 8/35 (IPoA mode).
DG-BG1100U User Manual
38