Interface
RJ-45 port, for connecting the router to a PC or other network
Ethernet
devices through Ethernet cable.
To restore the factory default, keep the device powered on, push a
Reset
needle into the hole for about 1 second, and then release.
Power
Power interface, for connecting the power adapter.
Power switch, on the side of power interface.
3. Hardware Installation
The router contains one Ethernet LAN, and a Line (WAN) interface. Place the Router in
a location where it can be connected to the various devices as well as to a power
source. The router should not be located where it is exposed to moisture or excessive
heat. Make sure the cables and power cord are placed safely out of the way so they do
not create a tripping hazard. As with any electrical appliance, observe common sense
safety procedures.
3.1 ADSL Connection of Router
1. Connect the Line port of the router and the Modem port of the splitter
with a telephone cable; connect the phone to the phone port of the
splitter through a cable; and connect the incoming line to the Line port
of the splitter.
DG-BG1100U User Manual
Description
10