EQ & Outputs Tab
The EQ & Outputs Tab section of the Audio page is shown in
Use this page to configure settings for the following outputs:
The Line Out 1 and Line Out 2 sections correspond to the l
unit, under the OUTPUTS labeling, and are marked 1 and 2.
The Amp Out section corresponds to the active amplified audio output. These outputs are located on the rear of the unit, under the
left card slot and are labeled 60W, 70V 100W, and 100V 100W.
Audio Page: EQ & Outputs Tab
FIG. 33
TABLE 19
Option
Save Settings button
Line Out 1/2 Settings
Mute
Volume (%)
Bass/Treble (%)
Master EQ (%)
N7142 User Manual
Audio Page: EQ & Outputs Tab
Description
Saves current configuration.
Mutes the audio input for the lineout audio outputs. These outputs are located on the rear of the unit, under the
OUTPUTS labeling, and are marked 1 and 2.
Sets audio output volume level.
Controls the frequency response of the audio output for high and low frequencies.
Controls the master equalizer adjustment for all frequencies.
Room Switcher Detailed Configuration Options
Figure
33. Options are described in
ineout audio outputs. These outputs are located on the rear of the
Table
19.
36