LG-Nortel iPECS-50 Administrator And Maintenance Manual page 60

IPECS Release 5
Admin & Maintenance
point-to-point connection over the managed WAN, including devices on the iPECS LAN. Note that
if the device's Router IP address is not defined, the system will use the Router IP address defined
in 102.
PGM CODE
The default codec employed by each device can be specifically defined as G.711, G.723, G.729,
G.722 or the system default codec
Note that the Sequence Number can be determined in
PROCEDURE:
BOARD BASE ATTRIBUTE
ENTER RANGE ( 001–143 )
001 BOARD ATTRIBUTE
PRESS FLEX KEY (1–7 )
Refer to Table 2.3.4.3-1
DISPLAY
Button ATTRIBUTE/DISPLAY
1
002-002 ROUTER IP ADDR
0 .0 .0 .0
2
002-002 DEV CODEC TYPE
(0-4): SYSTEM CODEC
3
002-002 FIRWALL IP ADDR
0 .0 .0 .0
4
002-002 RTP SECURITY
(1:ON/0:OFF) : OFF
5
001-001 TNET ENABLE
(0:ON/0:OFF) : ON
6
UMS SENDER MAIL
. . . . . . . . . . . .
7
T38 ENABLE
(1:ON/0:OFF) : OFF
PGM CODE
1. Press the [PGM] button and dial 132.
2. Use the dial pad to enter the Sequence Number range of the desired module.
Use
PGM CODE
3. Press the desired Flex button, refer to Table 2.3.4.3-1.
4. Use the dial pad to enter the desired data, refer to Table 2.3.4.3-1.
5. Press the [SAVE] button to store the Table data entry.
Table 2.3.4.3-1 BOARD ATTRIBUTES (PGM 132)
DESCRIPTION
Enter the default gateway (Router) IP address
associated with the selected devices.
Select the CODEC type for the selected devices:
0: G.711,
1: G.723.1,
2: G.729,
3: G.722
4: System Codec refer to
Enter the Firewall IP address associated with the
selected devices.
Remote iPECS terminals and the RSGMs use
IPSec to assure a secure connection. To reduce
bandwidth use, IPSec may be disabled.
When a module or station is to be connected in
a Centralized Control network (TNET), the
device must be enabled for TNET operation.
VSF/VMIM e-mail address for Mailbox Mail
Sending.
T38 mode ON/OFF for FAX data transfer
between other iPECS gateways.
2-41
161 can be defined.
103, Button 1.
PGM CODE
103 to determine Sequence Numbers.
161-btn 9.
PGM CODE
Issue 5.0
RANGE DEFAULT
0-3 3
0.0.0.0
0: OFF ON
1: ON
0: OFF ON
1: ON
NULL
1: ON OFF
0: OFF