Isdn Line & Iclid Routing Data - Pgm Codes 200-205; Isdn Attributes -Pgm Code 200 - LG-Nortel iPECS-50 Administrator And Maintenance Manual

IPECS Release 5
Admin & Maintenance
2.3.8 ISDN LINE & ICLID ROUTING DATA – PGM CODES 200-205-
Each ISDN (Integrated Services Digital Network) Line provides digital services to the end-user.
Basic Rate Lines have three (3) channels, 2 B channels and a D channel. The 2 B channels
provide 64 Kbps each, a total of 128 Kbps for "Bearer" or voice channels. The D channel provides
a 16 Kbps signaling channel. Primary Rate Lines have 23/30 64 Kbps 'B' channels and 1/2 64
Kbps signaling channels. For proper operation, entries are required for various attributes in
200 ~ 202 to match the ISDN circuit and services from the PSTN.
CODES

2.3.8.1 ISDN Attributes -PGM Code 200-

ISDN attributes define several characteristics of the ISDN interface.
(Advice of Charge), CLI modification, voice encoding, and other characteristics of the interface are
defined.
PROCEDURE:
SYSTEM ISDN ATT
PRESS FLEX_KEY (1-2)
Refer to Table 2.3.8.1-1
DISPLAY
Button ATTRIBUTE/DISPLAY
1
CO ATD CODE (2DGT)
..
2
CLI PRINT TO SERIAL
(1:ON/0:OFF) : OFF
2.3.8.2 CLIP/COLP Table -PGM Code 201-
Normally, the system will send the primary Directory Number of the ISDN Line in the ISDN call
SETUP and CONNECT messages to identify the caller (CLIP) or the answering (COLP) party
respectively. Under certain circumstances, it may be desirable to provide a secondary or DID
number for the ISDN Line. In these cases, the CLIP/COLP Table may be used to define the digits
sent. The number sent is selected based on the index assigned for the ISDN Line under CO/IP
Attributes III (
PGM CODE
For the CLIP/COLP Table entry, the CLI Station Number (
station number. For all other CLIP/COLP Table entries, the station number is sent as a suffix to
the number in the Table. There are 10 available entries for the iPECS-50 and MFIM100 and 50
1. Press the [PGM] button and dial 200.
2. Press the Flex button for the desired Attribute; refer to Table 2.3.8.1-1.
3. Use the dial pad to enter the desired Attribute data.
4. Press the [SAVE] button to store the Attribute data entry.
Table 2.3.8.1-1 ISDN LINE ATTRIBUTES (PGM 200)
DESCRIPTION
When the system is set to send the station
number with ISDN CLIP or COLP, either the
station number or this ATD code will be sent
based on
The ISDN Calling Line Id may be included in
call records output over the serial port
assigned for "Call Information",
btn 5.
143).
2-101
114 button 11.
PGM CODE
PGM CODE
PGM CODE
Issue 5.0
ISDN call cost services
RANGE DEFAULT
1~2 digits
0: OFF OFF
1: ON
175
114) is sent in place of the
PGM