Virtual Dip-Switch -Pgm Code 453- - LG-Nortel iPECS-50 Administrator And Maintenance Manual

IPECS Release 5
Admin & Maintenance

2.3.17 VIRTUAL DIP-SWITCH -PGM Code 453-

The Virtual Dip Switch is employed to change from in-band to SMDI for External Voice Mail
communications and manually poll each IP KTS device.
PROCEDURE:
VIRTUAL DIP SWITCH
PRESS FLEX KEY (1-6)
Refer to Table 2.3.17-1
DISPLAY
Button DISPLAY
1
VIRTUAL DIP SWITCH
DEVICE POLLING: (ON)
2
VIRTUAL DIP SWITCH
SMDI SETTING: (OFF)
3
VIRTUAL DIP SWITCH
MULTICAST LED: (OFF)
4
VIRTUAL DIP SWITCH
AUTO NEGO: (AUTO)
5
VIRTUAL DIP SWITCH
FULL-HALF: (FULL)
6
VIRTUAL DIP SWITCH
10-100 TX: (100)
1. Press the [PGM] button and dial 453.
2. To enable trace, press desired Flex button 1~6.
indicates Dip switch setting, On/Off. Press the desired Flex button to toggle
setting, LED On: enabled, LED Off: disabled.
3. To enable call trace, press the [SAVE] button.
Table 2.3.17-1 VIRTUAL DIP-SWITCH (PGM 453)
REMARK
'Device polling'. if enabled (On), the system
will check each registered device, Gateway
and iPECS Phone to determine if the device
is alive or not.
SMDI setting is enabled for output
If this value is set, the LED commands from
MFIM will be sent to gateways/terminals in
the multi-cast mode.
This field enables negotiation of speed
between the LAN switch port and the
system.
The duplex mode of LAN connections can
be set according to this field.
The speed of the Ethernet interface is
established based on this field, 10 Base T or
10/100 Base T.
2-142
Issue 5.0
The Flex button LEDs
RANGE DEFAULT
0: OFF ON
1: ON
0: OFF OFF
1: ON
0: OFF OFF
1: ON
0: AUTO AUTO
1: MANUAL
0: FULL FULL
1: HALF
0: 100 100
1: 10