Matrix E7XE-01 Service Manual page 64

9.18 crank arM rEplacEMEnt - continUEd
6) Remove the middle plastic cover from between the pedals by pulling it towards the rear of the unit (Figure I).
7) Remove the 3 screws holding the top roller track in place (Figure J).
8) Once the top track is removed, the crank arm can be removed from the unit.
9) Reverse Steps 1-8 to install a new crank arm.
10) Test the Elliptical Trainer for function as outlined in Section 8.21.
60
cHaptEr 9: part rEplacEMEnt gUidE
figUrE i
figUrE j