Troubleshooting - Pedals Slipping; Troubleshooting - Noise Issues - Matrix E7XE-01 Service Manual

8.8 troUblESHooting - pEdalS Slipping

poSSiblE caUSES:
1) The belt tension is not enough.
2) The one way bearing is damaged.
SolUtion:
1) Remove the covers and check the belt tension.
a. The drive belt should be tightened to 170 ft / lbs.
b. The ECB belt should be tightened to 85 ft / lbs.
2) If the belts are tensioned correctly, the one way bearing is damaged, replace the drive assembly.

8.9 troUblESHooting - noiSE iSSUES

poSSiblE caUSES:
1) The pedal is on the pedal arm too loosely.
2) The axle is worn out.
3) The belt tension is not enough, or the belts are too dirty.
SolUtion:
1) Retighten the pedal on the pedal arm.
2) Replace the axle as needed.
3) Remove the covers and check the belt tension.
a. The drive belt should be tightened to 170 ft / lbs.
b. The ECB belt should be tightened to 85 ft / lbs.
4) Clean the belts. If they are worn or will not clean, replace the belts.
34
cHaptEr 8: troUblESHooting
pEdalS Slipping
knocking or crEaking noiSE