Table of Contents
Advertisement
9.17 pEdal arM rEplacEMEnt - continUEd
3) Remove the pedal as outlined in Section 8.16.
4) Remove the 3 bolts that hold on the mounting plate at the crank arm / pedal arm joint (Figure D). Note the plastic washer that mounts at the
end of the shaft (Figure E).
figUrE d
5) Slide the pedal arm shaft out of the crank arm housing (Figure F) noting the order of the washers on the pedal arm shaft (Figure G).
figUrE f
6) Reverse Steps 1-5 to install a new pedal arm.
7) Test the Elliptical Trainer for function as outlined in Section 8.21.
cHaptEr 9: part rEplacEMEnt gUidE
figUrE E
figUrE g
57
Advertisement
Table of Contents
Troubleshooting
