Sabo 92-13H Instruction Manual page 52

eng 12 UNPACKING AND ASSEMBLY
to the lower part (2), using the supplied
7
nuts and screws (3) and following the indi-
cated sequence.
Position the angle supports (4) and (5),
respecting the right (R ) and left (L ),
sides, and attach them to the frame using
the four self-tapping screws (6).
Insert this frame into the canvas cover,
ensuring that it is correctly positioned
along the base perimeter. Hook all the
plastic profiles to the frame tubes with the help of a screwdriver (7).
Attach the plastic cover (8) onto the upper part of the frame using the four self-
tapping screws (9), and apply the lower stiffening cross-bar (10) using the screws
and nuts supplied (11) following the indicated sequence.
Insert the emptying lever (12) in its housing and fit the limit stop screw (13)
together with the nut (14).
3 (x 2) 6 (x 4) 9 (x 4) 11 (x 2) 13 - 14