Replacing The Glass Gasket And/Or The Glass - Enerzone Destination 2.3 Insert Installation And Operation Manual

5.1.4 Replacing the Glass Gasket and/or the Glass

It is a good idea to replace the glass gasket when the door gasket is replaced. The gasket is flat,
adhesive-backed, woven fibreglass. Remove the glass retaining screws (A) and clips (B) then both
metal frames (C) that holds the glass to the door frame (E). Lift out the glass (D) and pull off the old
gasket. This is a good time to clean the glass thoroughly.
The gasket must be centred on the edge of the glass. To do this easily, peel back a section of the
paper covering the adhesive and place the gasket on a table with the adhesive side up. Stick the
end of the gasket to the middle of one edge, then press the edge of the glass down onto the
gasket, taking care that it is perfectly centred on the gasket. Peel off more of the backing and
rotate the glass and press the next section onto the gasket. Do not stretch the gasket as you place
it. Continue until you get to the start and trim the gasket to length. Now pinch the gasket to the
glass in a U shape, all around the glass. Reinstall the glass, being careful to centre the glass
carefully in the door. Do not over-tighten the screws. Note that the two main causes of broken door
glass are uneven placement in the door and over-tightening of retaining screws.
Do not abuse the glass door by striking or slamming shut. Do not use the insert if the glass is
broken. To change the glass, perform the same operation described above.
25
Destination 2.3 Insert Installation and Operation Manual