Glass Care - Cleaning; Gasket Replacement - Enerzone Solution 2.5ZC Installation Instructions Manual

Hide thumbs Also See for Solution 2.5ZC:

Table of Contents

2.3.9 Glass Care – Cleaning

The ENERZONE SOLUTION 2.5ZC is designed to keep the glass clean under normal

operating conditions. If the ENERZONE SOLUTION 2.5ZC is operated continuously with the

combustion air controls closed, the glass will tend to get dirty unless the fuel, firebox and

glass are maintained at higher temperatures. To clean the glass, there are a number of

specially designed cleaners. Your authorized ENERZONE dealer can recommend a suitable

cleaner which is available in your area. Regular household glass cleaners will not clean

creosote and they usually contain ammonia that may stain the glass permanently.

WARNING: ONLY WASH THE GLASS WHEN IT'S COLD.

WARNING: DO NOT USE ABRASIVES SUCH AS STEEL PADS, STEEL WOOL OR

OVEN CLEANER AS THEY WILL SCRATCH THE GLASS.

Remove the doors from the unit and lay them on a clean, non-abrasive surface. To replace the

gasket around the door frame, first remove the old gasket and adhesive. Make sure that the

surface is totally clean before applying new adhesive (a high temperature silicone caulking

rated for at least 500ºF, 260ºC, is suitable) or adhesion problems may result. Apply the

adhesive inside the door groove (gasket channel) and install the new gasket with a gentle

pressure. Let dry for at least 24 hours. To replace the glass gasket, simply remove the glass

retainers holding the glass to the door frame. Remove the glass and peel off the gasket

surrounding it. Replace it by a new, self-adhesive glass gasket. The proper replacement

gaskets are available from your ENERZONE dealer in the following dimensions:

Gasket

Glass gasket

Door frame gasket

Middle door frame gasket

Length

Dimensions

51 ½" (131 cm)

"U" Shape self adhesive

41 ¼" (105 cm)

Flat ¼" x ½"

14"

(36 cm)

Round ¼" self adhesive

Table of Contents