Tools - Strong SRT 8202 User Manual

Wakeup Date:
Wakeup Time:
Duration:
When all settings have been made, use pq to move the highlight to Save and press ok to confirm.
To quit the timer without saving your settings, move the highlight to Cancel.
7.3.5 Parental Lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
enter a new PIN code in the Parental Lock menu.
Use pq to select Parental Lock from the System Setup menu and press ok to proceed. You will be
asked to enter your PIN code. (DEfAULT PIn: 1234)
Menu Lock:
Parental Rating:
New Password:
Confirm Password:
7.3.6 oSD Setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD Timeout:
OSD Transparency:
Load Default OSD Setting:
7.3.7 Audio Description Setting
This menu allows you to change settings for:
AD Service:
Use AD as default:
AD Volume Offset:
7.3.8 Auto Standby
Auto Standby is a feature that helps you reducing power consumption. When set to 30Min/1 Hour/2
Hours or 3 Hours, the receiver will switch to standby if it doesn't receive any commands during this
time. Set Auto Standby to Off to deactivate the automatic standby function.

7.4 Tools

Press MEnU in viewing mode to enter the Main Menu.
Select the Tools submenu with pq and press ok or u to enter.
Use pq to highlight the submenu of choice and press ok proceed.
Press EXIT to leave.
Use the 0~9 buttons to enter the date for the timed event.
Use the 0~9 buttons to enter the starting time.
Use the 0~9 buttons to enter the duration of the timer.
Locks the installation menu. You can set Menu Lock to On or Off.
Choose between: Off, 4 years and up to 18 years. Channels with a parental
rating above the chosen age will be protected with a PIN code (if available in
your local broadcast.)
Enter your new PIN code (4 digits) here.
Re-enter your PIN code here to confirm.
Sets the duration time of on screen banners and messages remove. The
range is 1~10 seconds or Always On.
To set the OSD transparency from Off ~ 40% with 10% steps.
Press ok to clear all OSD settings and reset to default values.
Off or On. If set to On then receiver will allow you to use Audio description.
Off or On. If set to On then audio description is enabled by default.
To set the AD Volume Offset -3 ~ 3 with 1 step. Default value 0.
17