Table of Contents
Advertisement
Date and Time settings are available only when GMT Usage is set to Off. Use the 0~9
Date:
buttons to enter the date. Press EXIT to proceed.
Date and Time settings are available only when GMT Usage is set to Off. Use the 0~9
Time:
buttons to enter the time. Press EXIT to proceed.
Time Display
Select On to display time on screen, Off to remove.
7.3.4 Timer Setting
This menu allows you to set up to 8 timed events for recording or waking up the receiver.
to select Timer Setting from the System Setup menu and press Ok to enter.
Use
pq
The receiver will display a list with 8 timers, followed by their respective status. Select the timer you wish
to set or change with
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode:
Choose between Off (Timer inactive), Once, Daily (Timer will be executed every day,
same time) or Weekly (Timer will be executed every week, same day, same time) and
Monthly (Timer will be executed every month, same day, same time).
Timer Service:
Choose between Channel (Timer will wake up the receiver) or Record (Timer will start to
record the scheduled event).
Wakeup Channel: Use
Use the 0~9 buttons to input the date for the timed event.
Wakeup Date:
Use the 0~9 buttons to input the start time.
Wakeup Time:
Use the 0~9 buttons to input the timer duration.
Duration:
When all settings are according to your wishes, use
confirm. To quit the timer without saving your settings, move the highlight to Cancel.
7.3.5 Parental lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
enter a new PIN code in the Parental Lock menu.
to select Parental Lock from the System Setup menu and press Ok to proceed. You will be asked
Use
pq
to enter your PIN code. (DEfaUlT PIN: 1234)
Menu Lock:
Locks the installation menu. You can set Menu Lock to On or Off.
Parental Rating: Choose between: Off, 4 years and up to 18 years. Channels with a parental rating above
the chosen age will be protected with a PIN code (if available in your local broadcast.)
New PIN code:
Enter your new PIN code (4 digits) here.
Confirm PIN code: Re-enter your PIN code here to confirm.
7.3.6 OSD Setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD Timeout:
Sets the time after which on screen banners and messages disappear. The range is
1~10 seconds or Always On.
OSD Transparency:
To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press Ok to clear all OSD settings and reset to default values.
7.3.7 auto Standby
Auto Standby is a new feature that helps you reducing power consumption. When set to 30 Min/1 Hour/2
Hours or 3 Hours, the receiver will switch to standby if it doesn't receive any commands during this time.
Set Auto Standby to Off to deactivate the automatic standby function.
7.4 Tools
Press MENU in viewing mode to enter the Main Menu.
Select the Tools submenu with
12
and press Ok to proceed.
pq
to select the channel the timer will wake up with.
tu
and press Ok or
pq
to move the highlight to Save and press Ok to
pq
to enter.
u
PaRT 1 • English
Advertisement
Table of Contents
